HD720 �120V Owner's Manual 9/17/98 9:54 AM Page 9
Installation
9
To prevent possible damage to yourNOTE: When replacing batteries it is
speakers and other components in youralways a good idea to replace both at the
audio system, it is important that ALLsame time. When the unit will not be
components, including the HD720 andused for an extended period of time, it is
receivers are turned off and unpluggedalso a good idea to remove the batteries
from their AC power source whenso that the potential for corrosion or
installing any new component.damage is avoided.
Connecting the HD720 to your audioConnect the power to a non-switched AC
system is simple. Using standard RCA-wall outlet, or to the accessory outlet on
to-RCA interconnect cords, connect the
left and rightFixed Audio Outputthe rear of another audio device in your
system and you are ready to go!
jacks a on the rear panel to the CD
input jacks on your receiver, surroundNOTE: When using the accessory outlet
processor or preamplifier.on another product to power the HD720
make certain that it has the ability to
If your system includes an optional,power a device that draws at least 14
external digital-to-analog converter, or watts of current in addition to the
if you are using a receiver or other pro-
cessor that has the capability to decoderequirements of other devices that may
be plugged into the accessory outlets. If
PCM digital input signals, connect theyou use a Oswitched� outlet, it is impor-
Coaxial Digital Outputjack �to tant to remember that the host product
the Datastream Digital input on themust be turned on in order for the
decoder. Make certain to use a coaxial-HD720 to operate.
style interconnect cable, as standard
audio cables will not perform as well.
Install the two AA batteries supplied with
the HD720Os remote by turning the remote
over so that you are holding the bottom
side up. Press lightly on the embossed
arrow on the cover, and gently slide the
cover towards you in the direction of the
arrow. Insert the batteries inside the com-
partment, being careful to follow the +
and � polarity indications at the bottom of
the compartment. Replace the cover by
placing it on the remote and sliding it
back towards the top of the remote. |
ACEC
